Forging Die 

Forging dies are usually made of high-alloy or tool steel. Dies must be impact- and wear-resistant, maintain strength at high temperatures, have the ability to withstand cycles of rapid heating and cooling. In order to produce a better, more economical die the following standards are maintained:

#The dies part along a single, flat plane whenever possible. If not, the parting plane follows the contour of the part.

#The parting surface is a plane through the center of the forging and not near an upper or lower edge.

#Adequate draft is provided; usually  5° to 7° for steel.

#Generous fillets and radii are used.

#Ribs are low and wide.

#The various sections are balanced to avoid extreme difference in metal flow.

#Full advantage is taken of fiber flow lines.

#Dimensional tolerances are not closer than necessary.

 

As Genc Tool&Die we are following above standards to produce a better , more economical forging die.